15
RECORDING
ENGLISH
To pause during recording
Press REC PAUSE (
8
).
Slide REC/MARK (
¶
) to the right to resume recording
(the track number changes).
To mark a track during recording
Slide REC/MARK (
¶
) to the right.
The current location is marked and the track number
increases by one for the subsequent material. Marks must
be set at least 1 second apart.
To switch the information shown in the display
Press DISPLAY repeatedly.
(See “Viewing the date and time” on page 9 for details.)
To prevent misoperation during recording
Slide KEY LOCK to the right (LOCK) to activate the key
lock function. All buttons (except LIGHT) become
inoperative.
To release, slide KEY LOCK back to the left (OFF).
• Key lock can also be used during stop or play mode (etc.).
To stop recording
Press STOP (
7
).
Notes
• No sound is output from the internal speaker during
recording or the rec-pause mode.
• The unit stops recording automatically when it reaches the
end of the disc.
• When operating from battery power, the power management
function will automatically turn the power off after a certain
amount of time if the unit is left in rec-pause mode (unless
the LSR function is ON).
• When recording from a CD or MD with INPUT SELECT set
to DIGITAL, the track numbers are recorded automatically.
• If a standard digital signal is not input to the DIGITAL IN
jack after REC/MARK (
¶
) or REC PAUSE (
8
) has been
pressed, “Din Unlock” appears in the display and the unit
switches to the stop mode.
• The REC indicator lights differently in the following
circumstances:
- During recording : lights steadily
- During rec-pause : blinks
- When the battery is low : blinks quickly (see “Battery
replacement” on page 7)
BACKSPACE
To cancel the recording, press BACKSPACE while
recording.
The recording is discarded and the unit enters rec-pause
mode again at the point where recording began.
Operation
1
Make sure the INPUT SELECT, INPUT LEVEL,
SOURCE, MIC ATTEN, and ANC switches are
set appropriately.
For the built-in microphone : See page 12.
For external microphones : See page 12.
For analog sources : See page 13.
For digital sources : See page 13.
2
Decide where on the MD you want to record
from.
Press STOP (
7
).
To record from the end of a previous recording (with PRE
REC)
Press REC PAUSE (
8
) to activate the rec-pause mode and
route the source signal through the memory cache, then
proceed to step
3
. (A track number is written when you
start recording.)
To start recording immediately from the end of a
previous recording (without PRE REC)
Slide REC/MARK (
¶
) to the right without setting the unit to
rec-pause mode. The unit immediately starts recording from
the end of the previously recorded material. (A new track
number is written automatically.)
3
Shift REC/MARK (
¶
) to start recording.
Notes
To take full advantage of the PR_REC function, be sure to
wait a few seconds between steps
2
and
3
.
4
When you’ve finished recording, press STOP (
7
).
The UTOC is updated automatically.
1
2
,
4
STOP
3
REC MARK (
¶
)
KEY LOCK
BACK SPACE
LIGHT
DISPLAY
REC PAUSE (
8
)