Marantz NA-7004, Руководство пользователя

Страница: 17 / 50

11
ENGLISH
Getting Started
Connections
Basic Operations Basic Operations
Advanced Operations
Troubleshooting
Explanation terms
Information
Specifi
cations
Index
[Using the remote controller]
Press the M-DAX button.
Each time this button is pressed, M-DAX changes as follows.
Off Low
High
Mid
The “M-DAX” indicator on the front display lights when M-DAX mode
is Low, Mid or High. (
v
page 34))
NOTE
M-DAX is compatible with PCM (48 kHz or lower), MP3, WMA, AAC
and two-channel analog sources.
Switching the display’s brightness
Press
[DIMMER]
.
100% 75%
50% 25% Off
• The display’s brightness switches each time the button is pressed.
• If you operate the buttons when the display’s brightness is set to
“Off”, the display temporarily lights at 25% brightness level.
• The “DISPLAY OFF“ indicator on the front display lights when
Dimmer is set to “Off”.
Listening with headphones
Plug the headphones into the headphone jack (PHONES).
Adjusting the Volume
Turn <LEVEL> .
NOTE
To prevent hearing loss, do not raise the volume level excessively
when using headphones.
Operations possible during playback
Tuner playback
Tuning in Broadcast Stations
Connect the antenna beforehand (
v
page 5).
1 Press
[TUNER]
to select the reception band.
DAB FM
AM
2
Tune in the desired broadcast station. (FM/AM only)
When a station is received, the “ ” will light.
q
To tune in automatically (Auto tuning)
Press
[MODE]
to light the “AUTO” indicator on the display, then
use
[, TUNING –]
to select the station you want to hear.
w
To tune in manually (Manual tuning)
Press
[MODE]
to turn off the display’s “AUTO” indicator, then
use
[, TUNING –]
to select the station you want to hear.
• If the input source is set to something other than “TUNER”, press
[TUNER]
to switch the input source to “TUNER”.
• The input source can also be switched to “DAB”, “FM” or “AM”
turning
<INPUT>
.
• If the desired station cannot be tuned in with auto tuning, tune it in
manually.
• When tuning in stations manually, press and hold [, TUNING –]
to change frequencies continuously.
• A humming sound may be heard when using a TV nearby while
receiving AM programs. If this happens, move the system as far
from the TV as possible.
n
To stop auto tuning
Press
[, TUNING –]
.
Setting the digital output
Set to output from the rear panel DIGITAL OUT terminal (COAXIAL,
OPTICAL).
During stop mode, press
[DIG. OUT]
.
Each time
[DIG.OUT]
is pressed, output from the DIGITAL OUT
terminal (COAXIAL, OPTICAL) on the rear panel is switched between
“On” and “Off”.
[Selectable items]
On : Outputs the digital signal.
Off
: Digital signal is not output.
• When digital output is turned off, the “DIG.OUT OFF” indicator
lights.
• When digital output is turned off, you can enjoy high quality audio
output from the ANALOG OUT terminal.
• The “digital output off” has a memory retention function where
the settings remain stored and unchanged even when the power
is turned off.
1.NA7004N̲ENG̲30A̲0714.indd 11 1.NA7004N̲ENG̲30A̲0714.indd 11 2011/07/14 11:37:08 2011/07/14 11:37:08