Marantz MV8300_U1B, Инструкция по эксплуатации

Страница: 71 / 92

EN
71
The Remote is capable of controlling four JVC video
recorders independently. Each of VCRs can respond to
one of four codes (A, B, C or D).
This Remote control is preset to send A code signals
because your VCR is initially set to respond to A code
signals. You can easily change your Remote and the VCR
to send and respond to B, C or D code signals.
When using four JVC VCRs, set four VCRs and their
Remotes to different codes, so that the Remotes can
operate these VCRs separately.
1
Set remote operation mode
Set the VCR/TV/CABLE/DBS selector to “VCR”.
2
Set remote control code for Remote
1 Press and hold A/B/C/D .
2 Press the Number key “ 1 ” for A code control
signals, “ 2 ” for B code control signals, “ 3 ” for
C code control signals, “ 4 ” for D code control
signals.
3 Press STOP (
7
), and release A/B/C/D .
3
Turn off VCR
Press POWER on the VCR.
4
Check remote control code for VCR
Press PLAY (
3
) on the VCR for more than 5
seconds.
●
The code currently set appears on the front
display panel.
5
Turn on VCR
Press POWER on the Remote.
●
The code transmitted from the Remote blinks
for a few seconds on the front display panel.
●
After the code disappears on the front display
panel, make sure that the VCR is turned on by
pressing
POWER on the Remote.
To control four VCRs with the same Remote
You can control four JVC VCRs by switching the remote
control code for the Remote between A, B, C and D
(
step 2 ), keeping four VCRs to different control
codes.
●
Press the Number key “ 1 ” for A code control signals,
“ 2 ” for B code control signals, “ 3 ” for C code control
signals, “ 4 ” for D code control signals. (To change only
the remote control code for the Remote, DO NOT
perform steps
3 to 5 .)
Changing
Remote Control
Code
(Ex.) To set Remote to B code:
Press in succession
Hold
down
Release
A/B/C/D
ABC
STOP
VCR
TV
CABLE
/DBS
2
-
2
2
-
1
5
2
-
3
1
NOTE:
When “POWER SAVE” is set to “ON”, you can not change the
remote control code. Before changing the code, set “POWER
SAVE” to “OFF” (
pg. 57).
IN F-1
+
POWER PLAY (
3
)
HM-DH40000U-EN64-71 1/28/3, 11:18 AM 71