10
Notes: The projected test pattern will probably have
some forms of geometric distortions as a result
of misalignment of the Anamorphic Lens to the
projector.
3. If the Test Pattern appears tilted on the screen
loosen the four locking screws on the Lens align-
ment collar and rotate the Lens to straighten the
pattern. Then tighten the four locking screws.
Refer to figure 8 on page 6.
Notes: Inside the Lens close to the front are two
vertical visible black masks. When the edge of
those masks are parallel with the Lens Holder
Post, the crosshatch should no longer be tilted.
Do not look directly into the Lens, look off
from the side at an angle.
4. Rotate the front part of the LN7101F Lens for the
best focus.
5. Using the appropriate tools loosen the three
screws on the Lens Holder Locking Ring while at
the same time
supporting the
Lens on the
bottom. Refer to
figure 28.
6. Adjust the
height of the
LN7101F Lens
so its vertical
center coincides
with the center
of the projec-
tor lens and the
crosshatch pat-
tern is centered
vertically on the
screen. Tighten the center screw on the Locking
Ring and then rotate the LN7101F Lens left to right
to center the crosshatch pattern horizontally on
the screen. Then tighten the two screws previously
loosened on the Locking Ring.
7. The final adjustment is to straighten the lines of the
crosshatch test patern. Loosen the tilt adjustment
screw located near the Lens Holder. The front of
the LN7101F Lens can be pivoted up or down to
straighten the lines in the test pattern. Then tighten
the screw to retain the position.
Note: If the screen used is not a curved anamorphic
screen, some geometric distortion may be visible.
8. Proceed to Operation.
LN7101F Lens Alignment, con’t
Figure 28
Locking Ring
Screws
Tilt
Adjustment
Screw
Locking
Ring
Operation
Change the Aspect Ratio setting on the Marantz VP-
11 Projector by performing the following step:
1. Switch On the projector and press the ASPECT
Ratio Push-button until the “V-STRETCH” Mode is
selected using the Projector’s Remote Control.
Specifications
Lens
1.33x (2.35:1 Cinemascope)
Operating Temperature and Humidity
41 to 95
o
F (5 to 35
o
C), 30 to 85%
Overall Dimensions including Projector
Width is 20-1/16 inches (50.9cm)
Height is 9-13/16 inches (24.9cm)
Depth is 21-15/16 inches (55.7cm)
Weight
23 pounds (10.4 kg) net, 36 pounds (16.3 kg) in shipping
carton
