Manzano Laser Works Junkers Ju 88, Инструкция по сборке, Страница: 8 / 17

Assembly Manual for Junkers Ju 88
Copyright 2007 Thomas A. Jacoby and WarbirdKits.com 8
Using 3/32 balsa, plank the fuselage top and bottom
from F3 to the tail. The grain of the planking should be
perpendicular to the fuselage center line.
Glue the two F10 pieces together.
Using F10 to maintain the shape of the fuselage, glue
formers F1 and F2 in place. Glue F10 in place. Using 3/32
balsa cross-grain, plank the bottom of the fuselage from F3
forward to F1.
Cut and fit a balsa block to carry the upper shape of
the fuselage forward from F2.
If you choose to make the nose window removable, fit
the plastic nose window molding to F1A. You can use dowels
and magnets to hold the nose window assembly in place.
Cut out the lower fuselage at wing saddle. Cut between
F3 and F3A, and between F6 and F6A.
20. Fit the wing in place, and drill for the mounting bolt.
Glue the lower fuselage cutout to the wing. Cut out a
hole for access to the mounting bolt.
Install the wing mounting bolt.
Assemble the battery tray.
Glue a ¼” wide strip of 1/16” balsa to each side of the
cockpit opening between F2 and F3. This provides additional
gluing area for the vacuum-formed plastic canopy.
Tail Surfaces
Glue the fin parts together. Glue the rudder to the fin,
or hinge it to the fin if you desire rudder control.
Glue a 3/16 hardwood dowel between the elevator
halves.
Hinge the elevator halves to the horizontal stabilizer.
Cover the fin, rudder, horizontal stabilizer and elevators
as desired.