Manutan 1650430, Руководство пользователя

Страница: 43 / 175

3
THANK YOU FOR CHOOSING OUR PALLET TRUCK. FOR YOUR SAFETY AND CORRECT
OPERATION, PLEASE CAREFULLY READ THE MANUAL BEFORE USE.
NOTE: All of the information reported herein is based on data available at the time
of printing. The factory reserves the right to modify its own products at any time
without notice or incurring in any sanction. Please verify with the factory for possible
updates.
1. General Specifications
2. To Attach Handle to Pump Unit
3. To Adjust Release Device
Special fork length are available 800, 900, 950, 1000, 1500, 2000mm.
Materials and specification are subject to change without notice.
Capacity (kg)
200 ( or 190)
85 (or 75)
450 / 520 / 550 / 685
160
Ø 80x70(or Ø 74x70) Nylon, Polyurethane
Ø 200(or Ø 180) Nylon, Polyurethane, Rubber
2000 2000 2500 2500 3000 3000
1150 1220 1150 1220 1150 1220
Max. Fork Height (mm)
Min. Fork Height (mm)
Fork Length (mm)
Width Overall Forks (mm)
Individual Fork Width (mm)
Load Wheel Diameter (mm)
Steering Wheel Diameter (mm)
2.1 Remove 3 bolts (D611) from the handle bracket (D151).
2.2 Set handle (D610A, D610B or D610AS) on the bracket (D151), notice to allow the
chain (D612) and the adjusting bolts (D614) assembly to pass through the hole
in the center of the bracket (D151) and shaft (D153).
2.3 Insert the 3 bolts (D611) through the handle into the bracket (D151), then tighten
them securely.
2.4 Raise the lever plat (D132) and insert the adjusting bolt (D614) into the front slot,
keeping the adjusting nut (D615) on the under side of the lever plat (D132).
On the draw-bar of this pallet truck, you can find the control handle (D608 or D608S)
which can be regulated in three positions :
Raise
- handle down
Drive position - handle in center position
Lower
- handle up, the lever moves back the drive position when released.