Manupro MPSOR216MM, Инструкция пользователя

Страница: 32 / 96

32 GB
14. Troubleshooting
Fault Possible cause Remedy
Motor does not work Motor, cable or plug defective, fuses burnt Arrange for inspection of the machine by a
specialist.
Never repair the motor yourself. Danger!
Check fuses and replace as necessary
The motor starts
up slowly and does
not reach operating
speed.
Voltage too low, coils damaged, capacitor
burnt
Contact the utility provider to check the voltage.
Arrange for inspection of the motor by a special-
ist. Arrange for replacement of the capacitor by
a specialist
Motor makes exces-
sive noise
Coils damaged, motor defective Arrange for inspection of the motor by a special-
ist
The motor does not
reach its full power.
Circuits in the network are overloaded
(lamps, other motors, etc.)
Do not use any other equipment or motors on
the same circuit
Motor overheats eas-
ily.
Overloading of the motor, insufficient cool -
ing of the motor
Avoid overloading the motor while cutting,
remove dust from the motor in order to ensure
optimal cooling of the motor
Saw cut is rough or
wavy
Saw blade dull, tooth shape not appropriate
for the material thickness
Re-sharpen saw blade and/or use suitable saw
blade
Workpiece pulls away
and/or splinters
Excessive cutting pressure and/or saw
blade not suitable for use
Insert suitable saw blade
Service information
Please note that the following parts of this product are subject to normal or natural wear and that the following parts are
therefore also required for use as consumables.
Wear parts*: carbon brushes, saw blade, table inserts, sawdust bags
* Not necessarily included in the scope of delivery!