Customer Support 1.800.897.9755 x1 [email protected] 13
Customer Support 1.800.897.9755 x1 [email protected]
{15}
{15}
{15}
{33}
{31}
Center and level the TV on the TV Brace.
Make sure the center of the brace is aligned with the
center of the TV before leveling. Move on to STEP 4.4
once the TV is level.
If the TV sags to one side, carefully slide it sideways in the
opposite direction up to a MAXIMUM of 2 inches, until it
levels.
If the TV is now level but appears noticeably off-center
above the mantel, remove the TV and relocate the Wall
Plates {32} an equal distance in the opposite direction to
compensate. Repeat STEPS 3.3 and 3.4.
If you experience additional issues leveling the TV, refer
to “TV Leveling” in the Troubleshooting Tips on page 18.
Attach the TV Brace to the Vertical Braces.
Install four Screws {15} through the TV Brace {33} and
into the Vertical Braces {31}.
CL
2 inches
MAX
2 inches
MAX
Carefully hang the TV on the TV Brace.
Make sure that all the hooks on the Vertical Braces {31}
engage the TV Brace {33}.
If the Lifting Arm {35} appears to be too close to the
mantle, remove the TV. Refer to STEP 5.3 and make an
adjustment to the Bottom Stop positions. Repeat this
process until the Lifting Arm is a safe distance from the
mantle when the TV is installed.
Do not allow the TV to drop far enough to cause
the Lifting Arm to hit the mantel.
4.2
4.3
4.4
Attach the electrical and signal cables to the TV.
Ensure each segment of the cables has extra length
so that they are not stressed/kinked when the mount
moves.
Ensure that
cables do not
get pinched
behind
the tilting
mechanism
when the
mount is raised.
4.5
{31}
{33}
{35}
