FANWOOD
u
MM4100
1
(Figure 11)
Place the surround speakers along side and slightly to
rear of the seating area.
(Figure 12)
Install the surround speakers two to three feet above li-
steners.
(Figure 13)
Aim the surrounds speakers straight across, not the li-
steners area.
Troubleshooting
The remote control is not working.
Make sure is Power Switch is On.
Make sure are batteries in remote control.
Change the distance or angle.
No sound from speakers or no power.
System does not connected with power.
Check with the power plug.
The speaker cables are not connected (or are con-
nected wrong) with the output connector. Check the
speaker cables.
The power does not switch ON. Make sure
the power switch at the back panel is on.
No sound effect from speaker
when choose DVD output mode
Make sure the setup of DVD player. Please change
output mode in DVD setup into 5.1 CH.
Distortion occurred when in high volume
The sound device has too high level signal output.
Turn down the volume in source device or the master
volume in the system.
Note!
The proper combination of input and output mode
(both the active subwoofer and the supply source AUX or
DVD) will produce optimize sound quality. Please refer to
both Instruction Manual.
Note!
Some DVD device has high level signal output.
When the master volume is turn high until the distortion
occurs, please turn down the master volume to prevent da-
maged to the speakers and amplifier.
No bass
Check the Subwoofer volume is not mute.
Specification
Power output:
120 W
Subwoofer:
30 W
Satellites:
25 W x 2 + 10 W x 2
Center:
20 W
Frequency Response:
30Hz~20kHz
S/N Ratio:
>65dB
Power Supply:
~230V/50~60MHz
