AVS A-SERIES INSTALLATION MANUAL - GEN 2 VER 5
5
Introduction
Please read the entire instruction manual before attempting installation. As all cables are black please take
care when making all connections.
Insurance star ratings are only valid when installed by a registered
AS/NZS installer and installed in accordance with methods and principles detailed in AS3749.2
PLEASE ENSURE BOTH 12v SUPPLIES ARE FUSED, EITHER USE A FUSED SUPPLY FROM THE VEHICLE FUSE BOX
OR IF CONNECTING TO IGNITION SWITCH LOOM YOU MUST ADD INLINE 10a FUSES.
ALL CONNECTIONS MUST BE SOLDERED AND TAPED. DO NOT USE SCOTCH LOCKS OR SIMILAR
CONNECTORS.
General system features
Poly-fuse protected inputs/outputs:
The AVS A-Series includes poly-fuses on all inputs and outputs except the immobiliser circuits. If the poly-fuse
detects an overload, it will open to prevent damage to the alarm components. Once the overload has been
removed the polyfuse will automatically reset. If you find a circuit does not work (i.e. central locking operates
several times then stops) check the current draw on the affected circuit, as it may be too high. The polyfuse
may take several minutes to reset.
Auto-immobilisation:
The AVS system will automatically immobilise 38 seconds after the ignition is switched OFF. The LED will light
solid to indicate it is in auto immobilise mode.
Arm by remote:
Press the
button on the remote. The indicators will flash once and the siren will chirp once (if fitted). If
the central locking is connected the doors will lock. The LED light will stay on solid for 38 seconds and then
flash.
Silent arm: Push the
and
button together.
Door ajar warning:
If the siren chirps for three seconds on arming, a door, bonnet or boot is open. The alarm will exclude that
zone until it is properly closed and the alarm is disarmed then armed again.
Disarm by remote:
Press the
button on the remote. The indicators will flash twice and the siren will chirp twice (if fitted). If
the central locking is connected the doors will unlock. The LED will stop flashing.
Silent disarm: Push the
and
button together.
NOTE: If the alarm was activated while armed the system will flash the indicators and chirp the siren (if fitted)
four times upon disarming.
Low remote battery warning:
When the battery in the remote is almost flat the remotes LED will flash instead of lighting constantly when a
button is pressed.
Panic/car finder:
