INSTALLATION
1. This power supply is designed for indoor use only , put the unit in a well ventilated place and allow at least 50mm(2 in.)
space on two sides and the back to allow sufficient fan cooling.
2. Check for the correct input AC voltage with the rating label on the power supply
Make sure your mains plug is of 3 pin version and the ground pin is effective as the grounding of the power supply will
prevent electrical shock caused by leakage.
3. Turn on the power supply for a few minutes , the power switch(1) should be lit and the indicator (2) should be in green.
4. Turn off the power supply and connect the equipment with correct polarity.
5. Turn on the power supply first , then turn on the equipment .
6. When the operation is finished, turn off the equipment first , then turn off the power supply.
REMOTE CONTROL
ENABLE AND DISABLE THE OUTPUT
You can use Port 7 and 8 to remote control the OUTPUT ON/OFF.
a) Open Port 7 and 8 if you want to ENABLE the output ( By default )
b) Short Port 7 and 8 if you want to DISABLE the output.
Set up the provided remote connector plug
(a)
Remove the black portion of the remote control connector plug by removing the screw as Fig 1.
(b)
Solder 2 wires(22AWG) to PORT 7 & 8 of black portion as shown in Fig.2.
(c) Make sure the load is disconnected and the power supply is OFF.
(d)
Plug the remote connector plug into the remote control terminal of the power supply.
(e)
Secure the remote connector plug to the terminal socket by locking connector ring(Fig 3).
Black portion
Silver portion
Fig. 1
Outer ring
Fig. 3
Fig. 2
Port numbers are marked on the
black portion
2. Rotate the black portion
1. Remove the screw
