Manson Engineering Industrial CBC-9140, Руководство по эксплуатации

Страница: 11 / 15

DC Source 13.5V
All 3 battery type LED are on at the same time in DC source mode.
Charger can be used as a constant 13.5V voltage DC source with start upload
limited to 2AMP and subsequent maximum continuous 28Amp load without the
battery.
Battery with load
A load can be connected to the battery during charging as long as the load is
not larger than the rated output of the charger. The maximum continuous load
should be less than 28Amp.
Supplied Accessories
Battery temperature sensor (only for lead acid based battery)
When connected to the battery temperature sensor, the charging voltages
changes inversely with the battery temperature such that charging voltage
decreases with rise of temperature and increases with drop of battery
temperature.
Optional Accessory
Remote control Module
It is an extension of the front panel of the charger with full sets of LED
indicators & the SET button. You can monitor the charging status and do all
sorts of setting on the charger without getting to the charger which is most
likely installed at hard to access spot. This optional Remote Control Module
comes with a 10 meter connection cable.
Cable size recommendation for 40A
AWG Maximum Length (m)
10 2.5m
8 4m
Protection
Over Temperature Protection of battery
When this sensor detects the temperature of battery over 60ºC, the charger will
decrease the charging current to 1Amp. When the battery temperature reduce
back to 60 ºC.
Over Temperature Protection of charger:
At high operating temperature charger will gradually decreases the output
power to protect the electronic components from further thermal stress and at
the same time keeps a safe and continuous charging. The charger will
decrease output current in 3 levels, while the charger temperature keeps on
increasing, it will decrease output current to 30Amp first, then 20Amp and
finally 1Amp.
Short circuit protection by constant current method and auto reset when fault is
clear.
Reversed polarity protection with 25Amp x2 (CBC-9140)/ 25Amp (CBC-9220)
thermal fuse.
P.9