Installation Instructions
Specifi cations are subject to change without notice
Page 6
[email protected] | www.manrose.co.nz
Distributed by Simx Limited
Inline Extraction Fan Kits - 150mm Std Profi le
12. Connect the remaining piece of duct to the ceiling grille and onto the fan using the duct tape provided.
NOTE: Make sure wherever possible to keep the duct running in a straight line as this will improve the performance of the fan.
13. Make the electrical connection as follows:
Wiring of Standard Switching Models FAN5369 and FAN0803 (Diagram 2).
The fan can be connected to the light switch so that the fan will start when the light is switched on, or a dedicated fan switch (not supplied).
The fan should not be accessible to a person using either the shower or the bath.
Wiring of Timer Switching Models FAN5370 and FAN0804 (Diagram 3).
The fan can be connected to the light switch so that the fan will start when the light is switched on, or a dedicated fan switch (not supplied).
The fan should not be accessible to a person using either the shower or the bath.
NOTE: All wiring must be fi xed securely and the cable to the fan should be a minimum of 1mm
2
in section in section. All wiring
must comply with current regulations. This system should be installed by a registered electrician.
The timer mechanism supplied is a fully adjustable timer which is installed in the fl ush box. This means that the fan will run on for approx
0-20 minutes depending on settings (see diagram 2 for wiring instructions, and also instructions included with FAN2444 timer).
NOTE: There is an adjustable 0-5 minute delay time setting for switching the fan on.
INSTALLATION
