Manitowoc EC Serie, Инструкция по установке, использованию и уходу

Страница: 25 / 33

4-6
Maintenance Section 4
ICE THICKNESS PROBE REMOVAL
1. Compress the side of the ice thickness probe near
the top hinge pin and remove it from the bracket.
Ice Thickness Probe Removal
NOTE: At this point, the ice thickness probe can
easily be cleaned. If complete removal is desired,
continue with step 2 below.
WARNING
Disconnect the electric power to the ice machine at
the electric service switch box.
2. Follow the ice thickness probe wire to the
bulkhead grommet (exit point) in the back wall.
Pop the bulkhead grommet out of the back wall
by inserting fingernails or a flat object between
the back wall and the grommet and prying
forward. Pull the bulkhead grommet and wire
forward until the connector is accessible, then
disconnect the wire lead from the connector.
Ice Thickness Probe Cleaning
1. Mix a solution of ice machine cleaner and water
(59 ml of cleaner to 473 ml of water) in a container.
2. Soak ice thickness probe in container of cleaner/water
solution while disassembling and cleaning water circuit
components (soak ice thickness probe for 10 minutes or
longer).
3. Clean all ice thickness probe surfaces including all plastic
parts (do not use abrasives). Verify the ice thickness probe
cavity is clean. Thoroughly rinse ice thickness probe
(including cavity) with clean water, then dry completely.
Incomplete rinsing and drying of the ice thickness probe
can cause premature harvest.
4. Reinstall ice thickness probe, then sanitize all ice machine
and bin/dispenser interior surfaces.
WATER TROUGH REMOVAL
1. Apply downward pressure on the siphon tube and
remove from the bottom of the water trough.
2. Remove the water pump.
3. Remove the upper thumbscrew.
ICE
THICKNESS
PROBE
4. While supporting the water trough remove the
two thumbscrews from beneath the water trough.
5. Remove the water trough from the bin area
COMPRESS SIDES OF
ICE THICKNESS PROBE
SV1138A
UPPER
THUMBSCREW
SV1689-1
REMOVE SIPHON
TUBE
LOWER
THUMBSCREWS
SV1689-2