Manitowoc 16000WA, Руководство оператора

Страница: 36 / 110

Reference
Only
SET-UP AND INSTALLATION 16000 WIND ATTACHMENT OPERATOR’S MANUAL
4-6
Published 03-18-13, Control # 116-09
ASSEMBLE CRANE
Assemble the 16000 to the extent shown in Figure 4-4.
Follow the instructions in the Operator’s Manual supplied
with your 16000.
If an assist crane will be used to assemble and attach the
boom, do not install load block (3, Figure 4-4).
ASSEMBLE BOOM
Assist Crane Requirements
Either the 16000 live mast or an assist crane can be used to
handle and assemble the boom sections. See the Crane
Weights in Section 1of this manual for the weights of
components.
Blocked Crawler
To prevent the crane from tipping, some boom lengths must
be raised and lowered over the end of blocked crawlers. See
Capacity Charts for blocked crawler requirements and
Crawler Blocking Diagram in Capacity Charts Manual for
instructions.
Do not attempt to raise or lower the boom from or to the
ground until the crawlers are blocked, if required.
FIGURE 4-4
A10740-14a
Component Identification
Item Description
1 Live Mast
2 Handling Pendant (Mast and boom butt)
3 Load Block — 45 USt (41 t)
3a Dead-End Button Socket
4 4-Leg Lifting Sling (chain)
5 Operator’s Cab
6 Carbody Counterweight (both ends)
7 Crawler Assembly
8 Rotating Bed Adapter Frame (with Carbody)
9 Live Mast Assist Arm (1 each side)
10 Rotating Bed Jack (2 at Front)
11 Rotating Bed
12 Rotating Bed Jack (2 at Rear)
13 Boom Hoist
14 Crane Counterweight
15 Boom Hoist Wire Rope
1
7
5
4
6 (not shown)
8
9
10
11
14
15
2
3
13
12
From
Whip
Drum
3
3a
View A
View B