Manitou MT10044XT, Руководство оператора и сервисное руководство

Страница: 76 / 114

50960025/CP0514
72
PRINTED IN U.S.A.
EXHAUST FILTER SERVICE
The exhaust filter will provide several thousand hours
of maintenance free operation. At some point the
exhaust filter will require professional service to
remove accumulated ash buildup. Adhering to the rec-
ommended engine oil and diesel fuel requirements will
maximize the hours of operation before professional
service is required.
A diagnostic code will display in the multi-function
display screen to indicate when professional exhaust
filter service is required. This professional exhaust fil-
ter service must be performed by an authorized
Manitou Americas dealer.
STORAGE
If the Telescopic Handler will not be operated for a
period of three months or more, prepare and store it
using the following procedure:
NOTE: If the storage area is outdoors or in a
harsh environment, the storage procedure should
be followed if the Telescopic Handler is to be
stored for one month.
Before Storage
Perform the following prior to placing the machine in
storage:
1 Wash the entire machine.
2. Lubricate all grease fittings as described in the
Lubrication chapter of this manual.
3. Change engine oil as outlined in the Service and
Storage chapter of this manual.
4. Apply grease to all exposed hydraulic cylinder
rod areas.
5. Disconnect the battery cable clamps and cover the
battery or remove the battery from the machine
and store it separately.
6. If the ambient temperature (at any time during the
storage period) is expected to drop below freez-
ing, make sure the engine coolant is either com-
pletely drained from the radiator and engine block
or that the concentration of anti-freeze is adequate
to keep the coolant from freezing. Refer to the
separate engine manual provided for anti-freeze
recommendations and quantities.
Service As Required
During Storage
1. About once each month, connect the battery,
check all fluid levels to make sure they are prop-
er, and start the engine.
IMPORTANT: If it is desired to operate the
hydraulic cylinders at this time, BE SURE to wipe
the protective grease (and any adhering dirt) from
the cylinder rods prior to starting the engine. After
operating, BE SURE to recoat the cylinder rods
with grease if the machine is to be returned to
storage.
2. Allow the engine to run until it warms up and then
move the machine a short distance to help relu-
bricate the internal parts. Run the engine until the
battery is recharged and then shut it off.
After Storage
After removing the machine from storage and
BEFORE operating it, perform the following:
1. Change engine oil and filter to remove condensa-
tion and other residues.
2. Wipe off grease from cylinder rods.
3. Lubricate ALL grease fittings.
4. Follow the start-up and warm-up procedures out-
lined in the
Operation and Adjustments chapter of
this manual.
ProCarManuals.com