Manhattan SIMPLENET 506663, Быстрая установка

Страница: 3 / 16

ENGLISH
33
Adding Security to Your Adapter Network
The following steps are optional but highly recommended to ensure maximum
security — important in environments like apartment buildings, where a
wiring system is shared.
• If you are setting up your first two SimpleNet Powerline AV500 Ethernet
Adapters, once both of them are powered and connected to devices:
– Press the Security button on Adapter 1 for 1-3 seconds.
– Within 2 minutes, press the Security button on Adapter 2 for 1-3 seconds.
The Power LEDs will flash while the devices are
establishing a secure connection, then remain
lit once the connection has been established.
• If you’re adding more adapters to an established
network, follow the same procedure: set up the
new adapter, then — within 2 minutes — press
the Security buttons on each adapter for 1-3
seconds.
Note: If an added adapter was previously
installed on a different SimpleNet network, first
reset it to factory defaults by pressing the
Security (Reset) button for 12 seconds.
LED Status Indication
PWR On The adapter is powered and ready for operation.
Blinking rapidly The adapter is listening for other devices.
Blinking slowly The adapter is in a power-saving mode (Standby),
(4 seconds on, 8 off) which it enters automatically if no other adapter
can be found on the network.
Off The adapter is not operating.
PL Red A weak signal is providing a slow network speed
(below 50 Mbps).
Orange A normal signal is providing a standard network
speed (50-99 Mbps).
Green An excellent signal is providing an optimal network
speed (100 Mbps or above).
Off No activity/connection.
ETH On The adapter is linked.
Blinking The adapter is transmitting/receiving.
Off The adapter is inactive.