Setup & opeRAtiNG iNStRuctioNS
Prior to the initial use of the Bluetooth Audio Receiver, its built-in battery
needs to be fully charged. The first charge can take up to 4 hours, while
subsequent recharging may take less than 3 hours.
Charging the Battery
• Plug the included power adapter/recharger into an AC outlet, then
connect it to the In DC 5V jack on the receiver (above-left image).
• The middle LED (between the On/Off buttons) will light green to indicate
the battery is charging, then turn off to indicate a full charge (above-
right image).
Bluetooth Pairing and Operation
1. Connect your speakers to the 3.5 mm stereo Line Out jack on the
Bluetooth Audio Receiver.
2. Power on the receiver by pressing the On button, and keep it pressed
(for approximately 4 seconds) until the red and blue LEDs (between the
On/Off buttons) flash back and forth. The receiver is now in its pairing
mode.
NOTE:
Whenever the pairing between devices is not maintained
for a full minute or so, the pairing function will stop and need to be
re-established.
3. Turn on your Bluetooth-enabled device (mobile phone, PC, notebook,
etc.) and activate its Bluetooth pairing per the device’s BT instructions.
NOTE:
To play music using a Bluetooth-enabled mobile phone, the
phone needs to support A2DP and AVRCP profiles.
4. When your Bluetooth-enabled device locates the receiver and displays
it (as “BT Speakers”) in its Devices list, select the receiver for pairing.
5. When the display of your Bluetooth-enabled device prompts you to
enter a PIN code, enter 0000 (zeroes). This should complete the
pairing process — indicated by the flashing blue LED — and place the
receiver in standby mode, automatically connecting to your Bluetooth-
enabled device.
6. At this point, the receiver is ready to relay sound to your speakers.
NOTE:
To avoid unwanted syncing, turn the receiver off when it’s not
in use.
161091_02_miniQIG.indd 2
1/4/10 10:02:26 AM
