9
Fig.A
Connect the power cord to the electrical mains as shown in the attached diagram:
5. start-up
The coffee machine must be started by qualified technical personnel approved by ACS-M&V
S.r.l.
Once the electric and hydraulic connections are completed, the user is urged to start the espresso
coffee machine with the following procedure in order to avoid damaging the appliance.
5.1 Charging the water in the boiler
1) Open the water supply on-off valve and make sure that the mains pressure is enough.
2) Switch on the machine just pressing the on/off button on the display Fig.A
3) Pull down the group lever
2
and one of the steam tap to remove the exceeded air during the filling
time.
4) Lift the lever (pay attention at the spring pressure) once the water comes out from the group. The
filling of the steam boiler will end automatically when the level will met. If the level will not met for
some reasons, an error
“AL10”
will pop up on the display, please make sure that the mains tap is
open and the water line pressure is sufficient. Shut down the machine and turn on again, if the
problem will not disappear contact an authorized service center.
5.2 Heating the water in the boiler
1) When the boilers are filled with the right quantity of water, automatically the elements will turn on.
2)
This machine is equipped with an automatic vacuum breaker valve, so it’s not necessary to open
a steam tap during the warm up.
6. Operating instructions
During the flow of espresso coffee, tea or steam, these substances can cause burns due to
accidental skin contact.
6.1 Serving of espresso coffee
1) Remove the filter-holding cup from the serving unit and fill it with a dose of ground coffee. Press
the ground coffee using the relative coffee presser and then insert the filter cup into the serving
unit.
2) Place one or two cups under the serving spouts.
3) Pull down the lever and then let it return to its original position. The coffee will begin to flow after
a short time. To obtain a greater quantity of coffee repeat this operation.
ATTENTION: follows the instruction 1.1 pag. 3
Note: Make sure that serving into the cup has taken place correctly. If serving has not occurred
correctly, see the chapter
“PROBLEMS AND SOLUTIONS”.
