dmc1
2861 Congressman Lane | Dallas, Texas 75220 | 800.877.6631 |
www.mssystems.com
Page
11
At this location, attach a single gang box to a wall stud at a center height
of normal wall outlets. Make sure the single gang box extends past the
wall stud and into the room so it will be flush with the sheetrock when it
is applied. Run the Red and Black shielded audio cables (included in the
AWPRX) from the master unit location to the AWP location. Secure the
audio cables with a loose knot after they have been pulled through the
single gang box. Secure the cables at the master. Label all cables.
Power Amp Installation – Stereo Upgrade
Run the MS7XSC
cable from the dmc1H
or dmc1HC wall
housing to the remote
power amplifier.
Run the MS5XSC
cable from the remote amplifier
to each volume control. From
each volume control, run the
MS2SXSC to each respective speaker as shown in figure
11.
The remote power amplifier should be located in a closet
or utility closet and should be located within 6 feet of a
standard NEMA 5-15R 120VAC receptacle. Install a 1-
gang and a 2-gang box at the location for the remote
amplifier on a stud. Allocate the 1-gang and 2-gang
boxes relative to one another as shown in figure 12. Run
all MS5XSC cables from the volume controls to the
remote amplifier’s 2-gang box.
Run the MS7XSC cable from the dmc1 to the remote
amplifier’s 1-gang box. The remote amplifier is designed
to mount over the 1-gang and 2-gang boxes on a single stud. Note: The
speaker cables CANNOT be located in the same gang box used for
120VAC wiring.
Figure 11 - Power amp wiring
Figure 12 - Power
amp installation
Dmc1H
MS7XSC
