INSTALLATION
1. Attached Rope To Disk
-
Thread rope through center hole in disk and tie a double knot
as shown below.
2.
Do not install Disc Swing over concrete, asphalt, packed earth, or any other hard
surface. See page 6 for more information on proper protective surfacing material.
3.
Confi rm that the supporting structure is secure, it will support at least 200 pounds, is
over level ground, and is no less than 6 ft on all sides from vertical elements.
4. Tree Limb Assembly
-Test tree limb to ensure that it will hold the weight limit of 200
lbs. safely. Obtain additional rope to attach the Disc Swing to the horizontal support. The
rope used should not be less than the quality, durability, and strength of UV stabilized,
3/8” twisted or braided polyester rope. Form a small noose at one end of your rope and
throw it over the tree limb. Run the other end of rope through the noose you created and
tighten fi rmly. Run the end of rope through the loop on the Disc Swing. Tie a minimum of
TWO tight knots fi rmly. Attach swing with a carabiner rated for maximum weight. Bottom
of swing should be no less than 15 in. from ground.
5. Swing set or other horizontal beam Assembly
- Attach the Disc Swing to a swing
set by removing one set of chains from an existing swing. For easiest attachment, use a
carabiner rated for a maximum weight of 200lbs. Clip the carabiner to the swing set loop
and then to the upper loop of the Disc Swing. The bottom of swing should be no less than
15 in. from ground. (See fi g.3)
Double overhand knot
Pull tight
More Fun Products from
Big Buck Tire Swing - MM00114
Chopper Ride’n Tire Swing - MM00117
Air Riderz
Extreme
MM00118
Air Riderz
with Disk
MM00128
Pony Pal Tire Swing - MM00107
WebRiderz Swing - MM00124
www.mandmsalesinc.com
