M&G 24V-25A, Инструкция по установке и эксплуатации

Страница: 8 / 11

Page 8
M&G Technologies, LLC | Cleveland, OH 44202
Maintenance
WARNING:
Disconnect from AC voltage before doing any service. When
plugged-in the AC wiring is an electric shock hazard. Disconnecting the DC
output (connection to battery) near the batteries when the charger is ON may cause the
batteries to explode resulting in serious injury or death.
WARNING:
Risk of an electric shock causing serious injury or
death. Do not touch un-insulated parts of the charger wires, battery connector
or battery terminals. Be careful with tools as shock or arcing from shorting of electrical
parts may cause serious injury or death. Remove rings, watches, and jewelry to avoid
arcing and electric shock.
1)
All electrical connections must be kept clean and tight. Sometimes connections can
look good outside but be corroded inside causing an output connection error (DC LED
will not light).
2) The charger cools through the case fins. If the fins become covered with debris the
charger’s over-temperature protection system may reduce charging power. Clean-off
fins to improve cooling.
3)
Replace the charger if case damage breaks the water-tight seal.
4)
Inspect wiring weekly, including AC plug, AC cord, DC wires to battery connector,
Battery connector, and interlock wires (if used) for cut insulation, pinching, or other
damage. Repair to avoid electric shock.
5) Follow battery supplier recommendations for battery care and maintenance.
Troubleshooting
WARNING:
Do not disassemble the charger. High voltages inside the charger
are an electric shock hazard and may result in serious injury or death.
WARNING:
Do not operate the charger if it is malfunctioning. Personal injury
or property damage could result. Electric shock hazard may cause serious injury
or death.