Manaras MSJ, Инструкция по установке и эксплуатации

Страница: 36 / 52

36
Table 12 - Mechanical Inspection Schedule (Part 2)
Time
Frame
Inspection
Once a
Year
•
Run the operator a few cycles:
◦
Make sure that the door rollers are rolling smoothly on the track.
◦
Listen to the motor: The motor should hum quietly and smoothly.
◦
Verify that the limits operate quietly and smoothly: investigate any unusual noise.
•
Verify that the mounting bolts are holding the unit securely.
•
Inspect the unit for evidence of corrosion.
•
Change the gear reducer's oil, at the very least, after every 2500 hours of operation or once a
year (if applicable).
1.2 Electrical Inspection
It is recommended that the electrical maintenance inspections be performed at the same intervals as the mechanical
maintenance inspections.
Table 13 - Electrical Inspection
Time Frame Inspection
Every Month

Inspect the unit for evidence of corrosion on electrical wires and connectors.

Inspect the wiring compartment and remove any dirt from the control units.

Verify all the grounding wires and terminals for corrosion. Be particularly careful to verify the
ground wires.

Verify the terminal strips to insure that all the screws are tightened.

Verify that the pneumatic edge or other entrapment protection devices installed on the
operator are fully operational.

Verify the voltage at the input terminals while the operator is running. The voltage must not drop
more than 10% momentarily. If the voltage drop is too deep when running, the relays may
chatter and the contact points will wear prematurely and may eventually seize. Verify the power
terminals for corrosion.

Verify the current consumption of the unit with an amp-meter. The current value should be
consistent with the nameplate specifications. Investigate any anomaly.
For technical support, please call 1-800-361-2260 or visit www.manaras.com for more information