Mammuth LT3HHM, Руководство пользователя

Страница: 15 / 21

ENG
15
Control
1. Put the moveable lifting table on the brake.
2. Place the load to be lifted centrally on the lifting table.
3. Remove the brakes from the rear wheels and then
drive the load-loaded lifting table to the destination.
4. Then put the lifting table back on the brake and then pump the foot pedal
up and down with the foot until the load reaches the desired height.
5. When the work table is raised to the maximum height, it drops a very small
piece.
6. Then fold the safety stop down to prevent accidental drops from the lifting
table.
7. When one is ready, pump the lifting table up a little, fold up the safety stop-
per and then lower
the lifting table gently and gently again.
4. Maintenance
WATCH OUT! Check the lifting table prior to ANY use for defects as described
in the Operation, Control
before use section. In addition, the lifting table should be cleaned after each
use, in order to prevent pollution, extra wear and/or corrosion. Failure to follow
these instructions may result in serious injury and/or damage to materials.
Monthly maintenance
Grease all the parts shown on the image next to it monthly, make sure this
should be done with oil or grease, this is indicated in the image.
WATCH OUT! In the image the LT50L is shown, the LT3HHM has the same lu-
brication points, only the LT3HHM should rub all the connecting pins (hinges)
of the scissor mechanism.
Annual maintenance
Replace the hydraulic oil in the cylinder every year.