Mamas & Papas Primo Viaggio I.P., Инструкции по безопасному использованию

Страница: 10 / 12

10
transport by hand and for attachment to a base, stroller or
chassis; Position C: allows the safety seat to rock; Position D:
stops the safety seat from rocking.
11• To fit the hood, insert the hood attachments into the slots
on the safety seat and arrange the rear part of the hood
behind the backrest.
12• The hood has two positions. To raise or lower the hood push it
back or pull it forward. To remove the hood, press the buttons
on its attachment points and at the same time lift it upwards.
• IMPORTANT: the hood must not be used to lift the safety
seat because it might detach.
Instructions for in-car use
13• Fit the car safety seat with the child on the car seat,
remembering to secure the child with the safety harness.
• The correct position of the safety seat in the car is parallel
with the ground, and so if necessary used rolled towels
under the safety seat to adjust the position.
14• Insert the webbing of the car seat belt into the two lateral
guides on the safety seat, ensuring that it is taut, and engage
the buckle of the car seat belt as shown in the figure.
15• Take hold of the car seat belt again and pass it behind the
backrest of the safety seat, inserting it into the rear guide
as shown in the figure.
16• In the car the handle must be fully lowered forward towards
the car seat backrest as shown in the figure. The correct
forward position is reached when it clicks into position. Check
that the seat belt is taut and locked to ensure adequate safety.
Removability
To remove the lining of the Primo Viaggio I.P. car seat:
• remove the hood for added comfort:
• Press the metal button positioned on the centre of the seat to
stretch the straps of the safety strap;
• press the red button on the leg divider to release the safety
strap.
17• remove the shoulder straps (Fig. a);
• from the front, remove the straps from the backrest (Fig. b);
18• release the hook of the leg divider from below the frame, and
pull it out;
19• slide on the headrest cover from the bottom first and then,
carefully, from the two side tabs;
BE CAREFUL NOT TO BREAK POLYSTYRENE (EPS) PARTS
20• remove the four installation tabs of the padding from the
edge of the car seat;
• remove the two covers of the lateral guides for the belt of the
car;
• remove the cover of the metal button placed in the centre of
the seat, detaching it from under the seat;
21• remove the padding in sequence, as shown.
Padding cleaning instructions
• Brush the fabric parts to remove dust and hand wash at a
maximum temperature of 30° without wringing.
• Do not use chlorine bleach.
• Do not iron.
• Do not dry clean.
• Do not remove stains with solvents and do not tumble dry.
Lining
• To replace the lining of the Primo Viaggio I.P. car seat:
22• slide the padding on in sequence, as shown: - slide the sack
on from the top - first put the lateral tabs of the headrest
carefully _ then slide it into the bottom of the headrest.
23• insert the four installation tabs of the padding from the edge
of the car seat;
• place the two covers of the lateral guides for the belt of the
car with the slots facing the inside of the car seat and make
sure that it is attached correctly;
• reposition the cover of the metal button placed in the centre
of the seat, attaching it from under the seat.
24• To slide on the headrest cover from the two lateral tabs and
slide on the bottom (Fig. a);
• attach the hook of the leg divider from below the frame (Fig.
b);
25•
IMPORTANT: the strap must not be twisted.
• Insert the straps in the backrest, as shown (Fig. a) from the
front (Fig. b) Attach the shoulder straps with Velcro (Fig. c).