11
M5 – Eco
CE
The hoses must not have breaks or bottlenecks so that the material
contained can flow freely.
If, in spite of all the procedures having been carried out correctly,
anomalous pressure values exist, put the machine on standby and carry
out a check as indicated in the present manual. Do not make
modifications, check the condition of the rotor and the stator. If the cause
of the problem is not discovered, turn the machine off and have it
examined by an authorised technician.
Make sure that the jet is not directed at people or dangerous objects
during the spraying phase.
After an emergency shutdown, the machine operator must make sure of
the cause of the problem in detail. This problem must be solved before
starting the machine up again to guarantee its correct functioning.
In the case of electrical problems, stops, strange noises or defects in
general, the machine must be immediately turned off at the main switch.
Only competent personnel can be authorised to solve electrical
problems. If the problem is not solved despite the information in
the present manual, turn the machine off and protect it from
possible accidental start-up. Then call the representative of your
zone to receive more detailed information.
Cleaning
Inadequate cleaning or failure to observe the cleaning regulations can
cause damage to the single parts of the machine or danger to people!
Cleaning must take place only with the machine off and in the absence of
electrical power (interruption of supply and protection from accidental
start-ups). The safety devices must not be deactivated or rendered useless.
It is necessary to check on the manometer that the pressure has
been completely emptied out before removing a hose. The
pressurised tubing must be completely emptied, depending
upon the type of hose, as indicated elsewhere in the present
manual.
Only a qualified electrician can carry out cleaning the inside of the
electrical box.
The use of detergents is forbidden to avoid damaging the plant.
Maintenance
Only the relative qualified technical personnel can carry out maintenance
work!
The machine must be turned off during maintenance work,
disconnecting it from the supply, turning the main switch off,
and removing the plug from the socket. The machine must be
protected from possible accidental start-ups!
No maintenance work can be carried out with the plant
functioning.
The safety devices installed on the plant must never be
tampered with. In the case of accidental tampering this
condition must be clearly indicated on the plant (e.g.
defective functioning of the machine). Modifications to the
safety system are not permitted!
ATTENTION
ATTENTION
www.markham-sheffield.co.uk - Tel: +44 (0) 1909 730861
