MPG525G
800-295-0042 ext 206
10
7. Route the wires to the rear, through the middle cross
member and along the frame. Install wire clips to secure
the wires between the cross members.
9. Using your
fi
ngers, separate
about 1” of the ends of the
harness. Strip about 3/8” of
insulation off each wire to allow length for wrapping
around the stiff tail light wire.
8. Route the harness around
the corner and allow the same
length harness as the length
of the tail light wires. Triple
check that the wires are routed
where you want them. Cut the
harness.
10. Hold the color matching harness and tail light wires
together with the end of the stripped insulation even with
each other, then wrap the harness
wire clockwise around the tail lamp
wire completely covering it.
11. Screw a wire nut down over
each until
fi
rm. Then tuck the wire
into a frame clip as shown.
FENDER ASSEMBLY (Group 4)
1. Loosely install fender
mounting brackets as shown
so they can move to
fi
t the
fender. Use hex bolts with
the nuts inside the frame.
2. Install and fully tighten
fender. Use screws and nuts,
nuts inside fender.
3. Fully tighten fender mounting brackets.
FENDER ASSEMBLY (Group 4)
6. Next, we’ll divide the wiring again. Direct the two(2) pigtailed end
towards the side running lights up front along the frame, and then the
three(3) pigtailed end towards the rear tail lights.
7. Route the wires to the rear, through the middle cross member and
along the frame. Install wire clips to secure the wires between the
cross members. Repeat on the other side of the trailer.
8. With the wires routed all the
lights, firmly grasp the wiring
connections and plug-in matching
colored leads/wires.
Repeat with all remaining lights.
MALONE
R
800-295-0042 ext. 215
9
