Malmbergs PSD008, Инструкция по эксплуатации

Страница: 21 / 28

21
POWER SUPPLY
PSD008 has a power supply mode setting which has a constant voltage of 13.8V and
current up to 5A, keep to provide power to computer system of modern car when
replacing battery (do not reverse battery connection to avoid the damage on the charger).
Temperature Compensation
A sensor will automatically adjust the charging voltage if the temperature deviates from –
20°C to +45°C.
Voltage compensation
Because of some voltage drop in the cables, the actual voltage at the clamps of the
battery can be lower than the charger output voltage. A special circuitry inside the unit
will monitor the true input voltage to the battery and adjust the output voltage of the
unit accordingly. This will maximize the charging efficiency.
Reverse-polarity protection
This unit offers reverse-polarity protection. Under charging mode, the RED LED will
illuminate and the charging process will not start. If this happens, unplug immediately
from mains, connect the red crocodile clip to plus (+) and black crocodile clip to minus (-),
then plug into the mains power and the charging process will start.
Short-circuit protection
Should you accidentally touch the crocodile clips together whilst the mains power is on,
the unit will not perform charging. Unplug from mains, disconnect and start the process
again being careful not to touch the clips together.
Charge Memory
If power off on charging, PSD008 can automatically restart charging based on previous
power down status for battery and charging current.
ATTENTION: Once the clamp of charger is disconnected from the battery, this memory is
erased and the charging mode will need to be reselected.
Other features
• Anti Spark Protection
• Battery and Charger Overheating Protection
• It will give a warning buzz while error occurs
• Waterproof Plastic Housing. Ingress Protection Rating IP65