Malmbergs Cosmos T5, Инструкция по эксплуатации

Страница: 14 / 16

14 15
Malfunction Possible Cause Remedy
The load will not
work despite
movement Incorrect light-control setting selected Adjust setting
Load faulty Replace load
Mains switch OFF Switch ON
Incorrect setting of detection area Increase the
detection area
The load is
always on Continuous movement in the detection area
because the detection area is too large Decrease the
detection area
The sensor is not mounted for reliably
detecting movement Securely mount
enclosure
TROUBLESHOOTING
TECHNICAL SPECIFICATIONS
CHANGING THE BULB
Switch off the power before changing the bulb. See Technical Specifications below, for
correct bulb.
Luminaire
Light source: 2x28W T5, 4W LED orientation light
Dims LxWxH: 1205x160x63 mm
Mounting: Ceiling
Connection: Fast connection terminal block 3x2.5 mm²
Protection Class: IP44
Sensor
Type of Sensor 5.8GHz Active Motion Sensor (CW radar, ISM band)
Operating Voltage: 220/240V~ 50Hz
Transmission Power: <1mW
Rated Load: 800W (resistive load), 400W (inductive load)
Detection Angle: 30-150°
Power Consumption: Approx. 0.9W
Reach: 1 m to approx. 5 m (radius), adjustable
Time Setting:*) 10 sec. - 25 min.
Light Control: 5-50Lux, adjustable
T5
To avoid a shortened lamp life, a general recommendation from manufacturers of lamps
is that the time setting has to be at least 15 minutes. This applies to luminaires with
fluorescent lamps, compact fluorescent lamps and energy saving lamps. *)