SAFETY : Read this First !
•
Do not connect the appliance if there are obvious signs of transportation damage.
•
Read this user manual thoroughly before attempting to use this appliance.
•
Installation and repair should be attempted only by qualified technical personnel.
•
It is dangerous to modify any part of this appliance.
•
The manufacturer declines all responsibility in case of failure to adopt proper safety
measures.
•
Ensure the location in which this appliance is installed has good, permanent ventilation.
•
The distance between the bench top to the lower part of the hood must not be at less
than 65 cm or higher than 75 cm.
•
Use an electrical connector with earth that is correct for your location.
•
Check that the voltage in your area is correct before plugging in.
•
The electrical connection of this appliance must be connected to earth.
Green & yellow
=
EARTH
Blue
=
NEUTRAL
Brown
=
LIVE
•
Multiple plugs and extension cables must not be used. Overload is dangerous and may
cause a fire.
•
Ensure that the power supply chord is free from any heat source or sharp objects.
•
The appliance should be switched off and the electrical supply disconnected before any
cleaning or maintenance work can be carried out.
•
This
appliance
is
not
intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction concerning use of the appliance by a
person responsible for their safety.
Children should be supervised to ensure that they do not play with the appliance.
•
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent
or similarly qualified persons in order to avoid a hazard.
Clause 7 (60335-2-31)
There is a fire risk if cleaning is not carried out in according with the instructions.
The hood use four hob element at most.
4
Cleaning & Maintenance
Before carrying out any cleaning or maintenance activities, ensure that the
appliances is disconnected from the mains.
To carry out cleaning and maintenance, follow the safety Instructions.
Filter Cleaning
To withdraw the filters from their locations release the anchoring points. Clean
the filter either putting in the dishwasher (refer to notes) or leaving it standing
in hot water to simplify the removal of grease or, if wished, by means of
special sprays (protecting the non metallic parts). Once clean, leave it to dry.
Notes: cleaning in the dishwasher with aggressive detergents may blacken
the surface of metallic parts, without this affecting its gas retaining properties.
The filter must be cleaned at least once a month depending on how often the
appliances is used. It must be remembered that grease is deposited in the
extractor when cooking, whether it is switched on or not.
Cleaning the appliances body
The use of (40ºC approx.) soapy water is recommended. A cloth moistened in
this water is used for cleaning the extractor, paying special attention to the
grids. Afterwards, dry it using a lint-free cloth.
Note: Never use metallic scouring pads or abrasive products that could
damage the surface. Do not use scrapers with metallic surfaces such as
knives, scissors etc.
9
