Assembly Instructions
Step
21
The measurement from top corner X to bottom corner X must be
equal to the measurement from top corner Y to bottom corner Y
a:
Fit the back panels
a:
Square up the unit by
making sure that
measurement
x:x equals
y:y.
Place the large back
and the 2 small backs
down onto the unit as
shown.
Make sure that
the 3 backs are
pushed up tight
against each
other and that
they meet over
the back edges
of the dividers.
b:
Nail around
the outside edges
of the 3 backs.
Note:
Do not nail where
the backs meet. Nails
should be spaced about
150mm apart.
Step
22
Secure the backs
Tap the nail screws
through the back holders
. and down between
the backs and
into the back edge
of the divider.
Keep tapping the
nail screws in
until the back
holders dig
into the small
and large back.
20
21
H
Q
P
P
Q
P
20
21
Q
P
y
x
x
y
y
y
Note:
Do not
nail where the
backs meet.
b:
H
20
21
21
20
21
21
Q
P
+
x 6
Q
P
+
x 6
13
