Malem Bed-Mat Enuresis Alarm
Instructions for MO3, MO4, MO5 and MO6
G
Under no circumstances should any of the alarms be
attached to the usersʼ clothing when using a Bed-Mat.
G
Place a clean and dry Bed-Mat correct side up over the mattress
in the area which is normally wetted and gently tie down.
G
Cover the Bed-Mat with a Clean Dry
Cotton sheet and/or Bath
Towel
and make the bed up as usual. Avoid nylon/polyester
sheets as they can cause ʻfalseʼ alarms due to increased
perspiration. Adjust cover thickness over the mat to suit.
G
Do not place plastic sheets directly under the Bed-Mat as
condensation will cause the alarm to trigger. (See diagram page 10)
G
Attach the Bed-Mat wire to the chosen Malem Alarm and place
the alarm beside the bed apart from the Vibrating alarm which
can be placed under the pillow.
G
Please tuck in the Bed-Mat wire so that it is not in the way for
getting in and out of bed.
G
Upon waking to the alarm, try to stop any more urine from
being released and use the lavatory to completely empty the
bladder.
G
The alarm sound can be stopped ONLY when the Bed-Mat wire
is unlocked from the alarm and the reset button is pressed.
G
The Bed-Mat must be wiped clean with detergent and dried then
replaced in a freshly made bed, as before, for reuse.
G
Adjust the loudness of the sound with the volume control.
(MO6 only)
G
To test the alarm, place a damp cloth across the foil tracks on the
Bed-Mat.
G
Bed-Mat sensitivity can be reduced by sliding switch on side of
MO6 Alarm. (See diagram on page 17)
9
