4
Settings
Sound selection: See page 9
The Malem wireless alarm is set
to 8 random sounds. If you wish
to change to a single sound, remove
receiver battery cover, slide all the
switches from 1 to 9 to off (leave 10 on).
Select any of the sounds from 1 to 8 by
sliding the switch to ʻOnʼ. Sliding switch
10 to ʻOffʼ will disable all sounds.
Only the LED will be activated.
Channel selection: See page 11
The Malem wireless alarm consists of a
matched pair of a transmitter and receiver.
To avoid interference from other wireless
equipment, you can change the channel.
A choice of 64 settings is possible.
Remove the back of the transmitter by using a
slotted screwdriver. Twist to open.
Change the setting of the code selection switch by moving any of the
switches in any of the 64 combinations.
Replace the back of the transmitter. Avoid disturbing the water-seal ring.
Re-tuning (Pairing) the receiver: See page 9
Push once then remove the straight end of a paper clip into the small hole
at the back of the receiver under the green LED. The green LED will glow.
Lower the lever of the
Easy-Clip©
(without material), the green LED will
flash and the alarm will sound. Lift the lever of the
Easy-Clip©
and press
the reset button on the top of the receiver.
The receiver and the transmitter are now automatically re-tuned again.
To prevent interference, use the same procedure when using more than
one pair of alarms in the same location.
Alternatively, you can tune several receivers to the same transmitter. This is
ideal if parents/guardians want an additional receiver in their bedroom.
1 2 3 4 5 6 7 8 910
1 2 3 4 5
6
Sound selection switch
setting for 8 random sounds
Channel Selection Switch
On
Off
1 2 3 4 5 6 7 8 910
For single sound selection
Select any one (1 - 8) to ʻonʼ
On
Off
