INSTALLATION OF THE LIGHT, OPERATION INSTRUCTIONS
Please pay attention to place your light in a non-shaded place with
sufficient sunshine provided for its operation.
Installation of the light:
Please fix your light on a hard surface
following the instructions below:
1.
Please care that the horizontal
surface you are about to fix your light on should be levelled correctly. It
is recommended to position the light on its final place, then mark the 2
locations of the holes.
2.
After marking the locations of the holes, remove the light, and drill the holes.
3.
Push the 2 screws together with the hit-in dowels on them inside the holes
with a hammer.
4.
Remove the nuts and the washers from the screws.
5.
Place the light on its final position on the screws.
6.
Place the washers then the nuts on the screws, drive the nuts by hand until
you can, then tighten them with a wrench.
Operation of the light:
1.
Turn ON the light by pressing the ON/OFF button on the top of the light.
The ON/OFF button is located on the LED panel.
2.
Charging by solar energy will start automatically during daytime.
3.
The light sensor turns on your light at dusk.
4.
Early in the morning the light sensor turns off the light.
To maximize the discharge time of your light, and preserve its good
aesthetical outlook, please follow the instructions given in “Cleaning
instructions” (please find this chapter below). PLEASE PAY EXTRA
ATTENTION TO THE RIGHT CLEANING METHOD OF THE POLYCARBONATE
PARTS (LED PANEL)!
5
Содержание ONYX EVOLUTION
Страница 2: ...2 ...
