Maktec MT954, Инструкция по эксплуатации

Страница: 6 / 8

6
Installing the wheel guard
Mount the wheel guard with the tab on the wheel guard band aligned with the
notch on the bearing box. Then rotate the wheel guard 180° clockwise. Be
sure to tighten the screw securely.
Installing or removing depressed center wheel
(optional accessory)
CAUTION:
• Always be sure that the tool is switched off and unplugged before
installing or removing the wheel.
Mount the inner flange onto the spindle. (THE SIDE WITH THE RUBBER
SURFACE SHOULD CONTACT THE WHEEL.) Fit the wheel on over the inner
flange and screw the lock nut onto the spindle.
To tighten the lock nut, press the shaft lock firmly so that the spindle cannot
revolve, then use the lock nut wrench and securely tighten clockwise.
To remove the wheel, follow the installation procedure in reverse.
1. Wheel guard
2. Bearing box
3. Screw
3
1
2
001647
1. Lock nut
2. Depressed center wheel
3. Inner flange
1. Lock nut wrench
2. Shaft lock
1
2
3
001648
1
2
001649