Maktec MT940, Инструкция по эксплуатации

Страница: 6 / 8

6
Replace an carbon plate on the cork rubber plate when it
is worn down. Remove screws on the strap washer and
the worn carbon plate, place a new carbon plate and then
secure it with the screws.
Replacing carbon brushes
1
001145
Remove and check the carbon brushes regularly.
Replace them when they are worn down to the limit mark.
Keep the carbon brushes clean and free to slip in the
holders. Both carbon brushes should be replaced at the
same time. Use only identical carbon brushes.
Use a screwdriver to remove the brush holder caps. Take
out the worn carbon brushes, insert the new ones and
secure the brush holder caps.
1
2
007747
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be
performed by Makita Authorized Service Centers, always
using Makita replacement parts.
1. Brush holder cap
2. Screwdriver
1. Limit mark