Maktec MT240, Инструкция по эксплуатации, Страница: 7 / 12

7
1
2
3
003988
If you use a spacer block which is slightly narrower than
the workpiece as shown in the figure, you can also utilize
the wheel economically when worn down the wheel.
1
2
3
4
5
003989
Long workpieces must be supported by blocks of
non-flammable material on either side so that it will be
level with the base top.
1 1
003990
OPERATION
Hold the handle firmly. Switch on the tool and wait until
the wheel attains full speed before lowering gently into
the cut. When the wheel contacts the workpiece,
gradually bear down on the handle to perform the cut.
When the cut is completed, switch off the tool and WAIT
UNTIL THE WHEEL HAS COME TO A COMPLETE
STOP before returning the handle to the fully elevated
position.
CAUTION:
•
Proper handle pressure during cutting and
maximum cutting efficiency can be determined by
the amount of sparks that is produced while cutting.
Your pressure on the handle should be adjusted to
produce the maximum amount of sparks. Do not
force the cut by applying excessive pressure on the
handle. Reduced cutting efficiency, premature
wheel wear, as well as, possible damage to the tool,
cut-off wheel or workpiece may result.
Cutting capacity
Max. cutting capacity varies depending upon the cutting
angle and workpiece shape. Applicable wheel diameter:
355 mm
Cutting
angle
90° 115 mm 119 mm
45° 115 mm 106 mm
Workpiece
shape
102 mm × 194 mm
70 mm × 233 mm
137 mm
115 mm × 103 mm 100 mm
Cutting
angle
90°
45°
Workpiece
shape
003991
Carrying tool
003992
Fold down the tool head to the position where you can
attach the chain to the hook on the handle.
1. Blocks
1. Diameter of
workpiece
2. Guide plate
3. Spacer block
4. Width of spacer
block
5. Vise plate
1. Guide plate
2. Straight piece of
wood (Spacer)
3. Over 85mm long