Maktec MT190, Инструкция по эксплуатации

Страница: 7 / 12

7
For tool with standard planer blades
To remove the blades on the drum, unscrew the three installation bolts with
the socket wrench. The drum cover comes off together with the blades.
To install the blades, first clean out all chips or foreign matter adhering to the
drum or blades. Use blades of the same dimensions and weight, or drum oscil-
lation/vibration will result, causing poor planing action and, eventually, tool
breakdown.
Place the blade on the gauge base so that the blade edge is perfectly flush
with the inside edge of the gauge plate. Place the adjusting plate on the blade,
then simply press in the heel of the adjusting plate flush with the back side of
the gauge base and tighten two screws on the adjusting plate. Now slip the
heel of the adjusting plate into the drum groove, then fit the drum cover on it.
Tighten the three installation bolts evenly and alternately with the socket
wrench.
For the correct planer blade setting
Your planing surface will end up rough and uneven, unless the blade is set
properly and securely. The blade must be mounted so that the cutting edge is
absolutely level, that is, parallel to the surface of the rear base.
Below are some examples of proper and improper settings.
004841
1. Bolt
2. Drum
3. Planer blade
4. Drum plate
5. Adjusting plate
1
2
3
4
5
002555
1. Inside edge of gauge plate
2. Blade edge
3. Planer blade
4. Adjusting plate
5. Screws
6. Heel
7. Back side of gauge base
8. Gauge plate
9. Gauge base
1
2
3
4
5
6
7
8
9
002556