Maktec M420, Инструкция по эксплуатации, Страница: 5 / 8

5
With the blade teeth facing forward, place the shank of
the blade over the flat side of the blade holder shaft.
Then place the blade clamp over the other side of the
blade shank. Secure this assembly together with the bolt.
Make sure that the bolt passes through the larger hole in
the blade shank.
1
2
3
4
5
009657
Adjusting roller
1
2
009637
Loosen the bolt on the back of the base with the hex
wrench. Move the retainer so that the roller contacts the
blade lightly. Then tighten the bolt to secure the base
and the retainer.
However, when using the blade that does not have a
straight back, slide the retainer back so that the roller will
not contact the blade.
NOTE:
•
Occasionally lubricate the roller.
Hex wrench storage
1
009658
When not in use, the hex wrench can be conveniently
stored.
OPERATION
009639
CAUTION:
•
Hold the tool firmly with one hand on the main
handle when using the tool. If necessary, the front
part of the tool may be supported by the other
hand.
•
Always hold the base flush with the workpiece.
Failure to do so may cause blade breakage,
resulting in serious injury.
•
Advance the tool very slowly when cutting curves
or scrolling. Forcing the tool may cause a slanted
cutting surface and blade breakage.
Turn the tool on without the blade making any contact
and wait until the blade attains full speed. Then rest the
base flat on the workpiece and gently move the tool
forward along the previously marked cutting line.
Bevel cutting
009640
CAUTION:
•
Always be sure that the tool is switched off and
unplugged before tilting the base.
With the base tilted, you can make bevel cuts at any
angle between 0° and 45° (left or right).
Loosen the bolt on the back of the base with the hex
wrench and slide the base backwards.
1. Hex wrench
1. Roller
2. Saw blade
1. Pin
2. Hex socket head
bolt
3. Blade clamp
4. Saw blade
5. Slider