3
INSTRUCTION MANUAL
Important information you should know:
Make cuts only with sharp blades. Discs that are not
sharp do not cut properly and overload the engine. If
the saw does not cut accurately, refer to the
PROBLEM DETECTION table in this manual.
ALWAYS USE PROPER PROTECTIVE
EQUIPMENT WHEN OPERATING THIS
EQUIPMENT.
Important Safety Instructions
ATTENTION: When using power tools, always
follow safety precautions to reduce the risk of
fire, electric shock and personal injury, including
the following:
READ ALL INSTRUCTIONS
Double Insulation
Double insulation tools are constructed with two
separate layers of electrical insulation or double
insulation thickness between you and the tool's electrical
system. Tools built with this insulation system should not
be grounded. As a result, your tool is equipped with a
two-pin plug that allows the use of an electrical
extension without the concern of maintaining a
connection to the ground wire.
NOTE:
Double insulation does not replace normal safety
precautions when operating this tool. The isolation
system is to add protection against personal accidents
resulting from a possible failure in the electrical
insulation of the tool.
CAUTION: WHEN MAINTAINING, REPLACE
ONLY WITH INDENTICAL PARTS. Repair or
replace damaged wires.
SAFETY INSTRUCTIONS
FOR ALL TOOLS
Remove the adjustment key. Make it a habit to
ensure that the adjustment wrench is removed from
the shaft before starting the tool.
Keep the work surface clean. Disorganized areas and
work surfaces invite accidents
.
Do not use the saw in hazardous environments.
Do not use power tools in damp or wet or exposed to
rain. Keep the work area well lit.
Keep children away.
All visitors must be kept at a
safe distance from the work area.
Make the workplace childproof
by using padlocks,
master keys or by removing the ignition key.
Do not force the tool.
It will do the job better and
safer for the intended use. Use the correct tool.
Do not force the tool when doing work for which
it was not designed.
Use suitable equipment.
Do not wear loose
clothing, gloves, chains, rings, bracelets or other
accessories that could get caught in moving parts.
Shoes with non-slip soles are recommended. Wear
hair protection to secure it.
Always wear safety glasses.
Also wear a face
mask.
Secure
the part to be worked.
Use fasteners or
vises when you are unable to secure the workpiece to
the table and against the guide by hand or when your
hand is dangerously close to the blade.
Don't overreach. Keep your balance and your feet in
a comfortable position at all times. Keep tools in order.
Keep tools sharp and clean for better and safer
performance. Follow instructions on lubricating and
changing accessories.
Disconnect tools before servicing or changing
accessories, such as blades, tips, cutters, etc.
Reduce the risk of unintentional starting. Make sure
the switch is in the “OFF” position before connecting
the wire to the plug,
Use recommended accessories. Refer to the
instruction manual to check the recommended
accessories. Improper use of accessories can cause a
risk of accident for people.
