After the Motion-Activated Dual Head LED
Security Light has been mounted and plugged
in, it is now ready for use. Turn switch on top to
ON.
The motion sensor rotates and in the back of it
are 2 adjustment dials: TIME and LUX. The light
has been factory preset as follows:
TIME - Set at approximately 30 seconds.
LUX - Set for your Security Light to activate at
dusk when motion is detected.
If the above settings are not suitable for your
application, then these may be adjusted using
the steps below.
TIME PERIOD ADJUSTMENT (TIME)
The time period adjustment control dial sets the
duration that the Solar Security Light will remain
illuminated after the last detected motion. The
time period has an adjustable range of 10 sec-
onds to 1 minute.
To decrease the time period, move the dial
toward the ( - ) symbol.
To increase the time period, move the dial
toward the ( + ) symbol.
Test the time period by triggering the motion
sensor and measure the time period the light
stays on. Adjust the TIME control until the
desired illumination duration is reached.
A shorter TIME setting will conserve battery
life. For best results, use the shortest TIME
setting for your location as possible
.
LEVEL ADJUSTMENT (LUX)
The LUX dial controls the natural light level that
triggers the Solar Security Light and prevents
the light from operating during daylight hours.
Your Solar Security Light comes preset for acti-
vation at dusk.
To adjust for activation in a brighter setting,
move the dial toward bright (
)
To adjust for activation in a darker setting,
move the dial toward dark (
). (Should look
like a thin moon).
Once adjustments are made, move sensor back
into position with the arrows lined up.
Ensure the power switch on the main body of
your Security Light is in the OFF position
Leave the switch in this position for up to 3 days
and make sure the solar panel is placed in direct
sunlight.
OPERATING YOUR SOLAR SECURITY LIGHT
Extension cords for your solar panel are now available.
Each cord comes in 15 foot lengths and has the
appropri-ate plugs on either end.
DO YOU NEED TO EXTEND THE DISTANCE BETWEEN THE SOLAR PANEL AND LIGHT?
BEFORE THE FIRST USE OF YOUR SOLAR SECURITYLIGHT
Page 3
