Saturation
Pump the coil
Check Coil
Warning messages are shown on the bottom of the display during search. Messages that may
appear are as follows:
It appears on the display simultaneously with the saturation alarm sounding like a siren. This
happens when the search coil encounters a near surface or a very large object. The device
reverts back to normal operation if you lift the coil up. If the alarm and the message continues
along a long line, you may be over a long metal such as a pipe.
It appears when the trigger is pushed forward for ground balancing. Does not indicate any error
or problem. It only indicates what should be done.
It indicates an interruption in the search coil transmitter signal. The search coil connector may be
unattached, loose or disconnected. If you own another detector with the same coil connector,
please be sure that you have not attached the wrong coil by mistake. If none of the above exists,
the search coil or its cable may have a defect. If the issue continues when you change the search
coil, there may be an issue in the coil control circuit.
Messages
Page_24
