WARNING: DUST GENERATED FROM CERTAIN MATERIALS CAN BE
HAZARDOUS TO YOUR HEALTH. ALWAYS OPERATE THE DRILL IN A WELL
VENTILATED AREA. USE A DUST COLLECTION SYSTEM IF POSSIBLE
WARNING: THE USE OF ANY ACCESSORY OR ATTACHMENT OTHER THAN ONE
RECOMMENDED IN THIS INSTRUCTION MANUAL MAY PRESENT A RISK OF
PERSONAL INJURY.
UNPACKING
The drill press is delivered with the components shown on page 2. Check the parts received against
the list. Should there be any deficiencies or damage, you should contact the dealer where the
product was originally purchased immediately. Do not discard the packaging until the machine is
assembled.
The packaging consists of cardboard and appropriately marked materials which can be sent to a re-
cycling facility.
To protect the machine parts from moisture, a protective coating of light machine oil will have been
applied to the outside surfaces. Remove any excess with a paper towel.
Take care when lifting the head assembly, considering its weight.
Before use, the machine must be mounted, and securely bolted, to a strong, heavy workbench, of
sufficient height that you will be standing upright when working.
Ensure the work place is adequately lit, and that you will not be working in your own shadow.
ASSEMBLY
WARNING! During assembly ensure the drill press is disconnected from the
power supply.
Carefully remove contents from the packing box.
Select a firm, level surface on which to assemble the drill press.
BASE & COLUMN
1. Select the Base (11) and align the Column Support (8) over the large hole -
Fig. 1
.
2. Align the holes in the Column Support with those in the Base and secure in place using the bolts
and washers. Using a spanner, securely tighten all bolts.
3. We recommend then mounting the Base to a stable surface for proper support.
TABLE & HOLDER
1. Slide the Table Support (7) and Table (6) down the Column (13) and clamp it at a level that will
not interfere with mounting the Head Assembly (12) –
Fig 2
.
