Makita XVR01, Инструкция по эксплуатации

Страница: 7 / 24

7 ENGLISH
3. Loosen the jaw case with a wrench while holding
the joint with another wrench.
1
2
► 1. Jaw case 2. Joint
4. Remove the jaw pusher, spring, and pipe.
1 2 3
► 1. Jaw pusher 2. Spring 3. Pipe
NOTICE:
When installing the jaw pusher, be sure
to attach the spring to the jaw pusher.
To install the head assembly, perform the removal pro-
cedure in reverse. Be sure to tighten the jaw case and
nose piece with two wrenches firmly.
Hook
CAUTION:
Always remove the battery when
hanging the tool with the hook.
CAUTION:
Never hook the tool at high loca-
tion or on potentially unstable surface.
CAUTION:
When hanging the tool with the
hook, hang it carefully. Otherwise, the tool may drop
and cause an injury.
1
2
3
1
2
3
► 1. Groove 2. Hook 3. Screw
The hook is convenient for temporarily hanging the tool.
This can be installed on either side of the tool.
To install the hook, insert it into a groove in the tool
housing on either side and then secure it with a screw.
To remove, loosen the screw and then take it out.
Installing or removing the mandrel
container
NOTICE:
Be sure to install the mandrel container
to the tool before operating the tool. If the man-
drel container is not installed to the tool, the tool
will not operate.
To remove the mandrel container, rotate it counter
clockwise. To install the mandrel container, rotate it
clockwise.
1
► 1. Mandrel container