![background image](http://html.mh-extra.com/html/makita/xtw01/xtw01_instruction-manual_1723005006.webp)
6 ENGLISH
When you pull the eject lever, the bolt tip is ejected from
the tool.
1
►
1.
Eject lever
Battery power lamp
When the remaining battery capacity becomes low,
the battery power lamp blinks. Charge the battery or
replace the battery with fully charged one. When the
remaining battery capacity becomes much lower, the
tool stops and the battery power lamp lights up.
1
►
1.
Battery power lamp
Hook
CAUTION:
Be sure to attach the shoulder belt
included in the tool as the standard accessory.
Use the shoulder belt for carrying the tool, and
never use the hook for other purposes such as
the fall prevention at high location.
If the hook is
used for other purposes, excessive load may break
them and cause serious injury to the operator and
person around/underneath the operator.
CAUTION:
When you attach the shoulder belt to
the hook, be sure to attach it securely.
If it is attached
incompletely, the tool may come off and cause an injury.
CAUTION:
When carrying the tool using the
shoulder belt, be careful not to entangle the shoulder
belt with your body or objects and not to hit objects
with the tool.
Failure to do so may cause an accident.
CAUTION:
Remove the shoulder belt from
the hook before operating the tool.
Failure to do
so may lose your balance at operation and cause an
accident.
1
2
►
1.
Hook
2.
Shoulder belt
Attach the shoulder belt included in the tool as the
standard accessory to the hook for carrying the tool.
Remove the shoulder belt from the hook before operat-
ing the tool.
Electric brake
This tool is equipped with an electric brake. If the tool
consistently fails to quickly stop after the switch trigger
is released, have the tool serviced at a Makita service
center.
ASSEMBLY
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before carrying out any work on the tool.
Removing the outer and inner
sleeves
CAUTION:
Be careful not to allow foreign mat-
ter to enter the insides of the tool when removing
or installing the outer and inner sleeves.
1.
Loosen the two screws while holding the outer
sleeve. The outer and inner sleeves will be pushed up
by the springs built into the tool.
1
2
►
1.
Outer sleeve
2.
Screw