Makita XSJ03Z, Инструкция по эксплуатации, Страница: 8 / 20

8 ENGLISH
Hook
CAUTION:
Never hook the tool at high loca-
tion or on potentially unstable surface.
1
1
2
2
3
3
► 1. Groove 2. Hook 3. Screw
The hook is convenient for temporarily hanging the tool.
This can be installed on either side of the tool.
To install the hook, insert it into a groove in the tool
housing on either side and then secure it with a screw.
To remove, loosen the screw and then take it out.
OPERATION
Adjusting shear blade
Adjust the side blade L to prevent the curl of the
workpiece from contacting the cutting head and the
workpiece.
Loosen bolts with the hex wrench (5/32"). Move the
side blade L back and forth to adjust it. Then tighten the
three bolts with the hex wrench (5/32").
1
2
► 1. Bolt 2. Side blade L
Lubrication
NOTICE:
Use the standard machine oil for steel
or the mineral spirits for aluminum.
Before operation, always lubricate the following areas:
A The cutting area of the workpiece.
B The part of the center blade which contacts to the
workpiece.
C The both sides of the center blade which contacts
to the side blade L and side blade R.
A
B
C
C
Adjusting cutting head angle
CAUTION:
Make sure the cutting head is
secured in the position after adjusting the cutting
head angle. Otherwise the cutting head may rotate
during operation and cause serious injury.
Rotate the cutting head while pushing the rotation
button.
Release the rotation button when the cutting head is in
the desired angle.
1
► 1. Rotation button