11 ENGLISH
6
5
1
2
3
4
►
1.
Nylon cutting head
2.
Metal guard
3.
Spindle
4.
Hex wrench
5.
Tighten
6.
Loosen
1.
Turn the tool upside down so that you can replace
the cutting tool easily.
2.
Insert the hex wrench through the hole on the
motor housing and rotate the spindle until the spindle is
locked.
3.
Place the nylon cutting head onto the threaded
spindle directly and tighten it by turning in the tightening
direction as shown in the figure.
4.
Remove the hex wrench.
To remove the nylon cutting head, turn it in the opposite
direction while locking the spindle with the hex wrench.
Hex wrench storage
CAUTION:
Be careful not to leave the hex
wrench inserted in the tool head.
It may cause
injury and/or damage to the tool.
When not in use, store the hex wrench as shown in the
figure to keep it from being lost.
1
►
1.
Hex wrench
OPERATION
Correct handling of tool
WARNING:
Always position the tool on your
right-hand side.
Correct positioning of the tool allows
for maximum control and will reduce the risk of seri
-
ous personal injury caused by kickback.
WARNING:
Be extremely careful to maintain
control of the tool at all times. Do not allow the
tool to be deflected toward you or anyone in the
work vicinity.
Failure to keep control of the tool
could result in serious injury to the bystander and the
operator.
WARNING:
To avoid accident, leave more
than 15m (50 ft) distance between operators when
two or more operators work in one area. Also,
arrange a person to observe the distance between
operators. If someone or an animal enter the
working area, immediately stop the operation.
Attachment of shoulder harness
CAUTION:
Always use the shoulder harness
attached. Before operation, adjust the shoulder
harness according to the user size to prevent
fatigue.
Connect the clasp of the shoulder harness to the
hanger part of the housing. Put the shoulder harness
on. Be sure that the buckles are locked completely in
place.
2
1
►
1.
Clasp
2.
Hanger
