Makita XOB02, Инструкция по эксплуатации

Страница: 8 / 28

8 ENGLISH
9.
Cover the abrasive paper with the punch plate
with its positioning stoppers adjacent to the corner well
fit onto two of the side edges of the pad and sanding
base.
2 3
5 4
1
Fig.7
► 1. Abrasive paper 2. Punch plate 3. Positioning
stoppers 4. Pad 5. Sanding base
10. Push the punch plate over the abrasive paper to
make dust-suction holes.
11. To remove the abrasive paper, release the clamps
on both ends and take the paper off the pad.
Using abrasive paper with dust-
suction hole
Optional accessory
1.
Push and hold down the clamp lever on either
front or rear end of the pad, and slide it away from
the stopper so the clamp is released from its locked
position.
2. Pull the clamp lever outwards as far as possible to
create a space between the clamp and side wall of the
sanding base in which one end of abrasive paper can
be inserted.
3. Place a sheet of abrasive paper over the pad,
aligning the dust-suction holes in the paper with those
in the pad.
3
1
2
Fig.8
► 1. Abrasive paper 2. Pad 3. Dust-suction hole
4. Slip one end of the abrasive paper into the space
between the clamp and sanding base.
5. Set the clamp lever back in a locked position so
the end of abrasive paper is clamped securely.
6.
Release the clamp on the other end, and have the
other end of abrasive paper ready to be clamped.
7.
Maintain a proper tension on abrasive paper, and
then set the clamp lever on the other end in a locked
position.
4
2
1
3
5
4
2
1
3
5
Fig.9
►
1.
Abrasive paper
2.
Clamp
3.
Sanding base
4. Clamp lever 5. Stopper
8. To remove the abrasive paper, release the clamps
on both ends and take the paper off the pad.
Using hook-and-loop abrasive paper
CAUTION:
Make sure to install a hook-and-
loop pad correctly and securely. A loose attach-
ment will run out of balance and cause an excessive
vibration resulting in loss of control.
CAUTION:
Be sure that a hook-and-loop pad and
abrasive paper are aligned and securely attached.
CAUTION:
Only use hook-and-loop abrasive
papers. Never use pressure-sensitive abrasive
papers.
NOTICE:
The cap may come out of the sanding
base while replacing the pad. Be sure to set the
cap back in the circular hole around the center of
the base before installing the optional pad.
2
1
3
Fig.10
► 1. Cap 2. Sanding base 3. Circular hole