8 ENGLISH
Quick mode-switching button
The function of the quick mode-switching button varies
depending on whether you have registered the applica
-
tion mode to the tool.
1
►
1.
Quick mode-switching button
When the application mode is not
registered:
The level of impact force changes every time you press
the quick mode-switching button. The front lamps on
both sides will flash once when the impact force is
changed by pressing the quick mode-switching button.
When the application mode is registered:
The tool switches between the registered application
mode and current application mode every time you
press the quick mode-switching button. The front lamps
on both sides will flash once when the application
mode is changed by pressing the quick mode-switching
button.
NOTE:
When the lamp status is off, the lamps will not
flash even when the application mode is changed by
pressing the quick mode-switching button.
NOTE:
Refer to "Registering the application mode"
in "Quick mode-switching function" section for how to
register the application mode.
Disabling the quick mode-switching
button
You can also disable the quick mode-switching button.
After disabling, the quick mode-switching button will not
work for changing the impact force and switching the
application mode.
To disable the quick mode-switching button, press and
hold the quick mode-switching button and the but-
ton
at the same time until the all lamps on the panel
blink.
To resume the quick mode-switching button, perform
the same procedure as above again.
NOTE:
Registering and erasing the application mode
can be performed even if the quick mode-switching
button is disabled. After registering or erasing the
application mode, the quick mode-switching button
will be activated.
Quick reference
The following table shows the functions of the quick
mode-switching button.
indicates the quick mode-switching button.
Button(s) / Purpose
How to confirm
+
Registering the application
mode
The customize lamp and the
lamp of desired application
mode blinks.
(When quick mode-switch-
ing function is OFF)
Changing the impact force
by the quick mode-switch-
ing button
The lamps on the tool flash
once.
(When quick mode-switch-
ing function is ON)
Switching to the registered
application mode
The lamps on the tool flash
once.
+
Erasing the registered
application mode
The customize lamp and all
impact force grade lamps
blink.
+
Disabling/resuming the
quick mode-switching
button
All lamps on the panel blink.
