Makita UR012GT201, Инструкция по эксплуатации

Страница: 14 / 28

14 ENGLISH
ASSEMBLY
WARNING:
Always be sure that the tool is
switched off and battery cartridge is removed
before carrying out any work on the tool. Failure to
switch off and remove the battery cartridge may result
in serious personal injury from accidental start-up.
WARNING:
Never start the tool unless it is
completely assembled. Operation of the tool in a
partially assembled state may result in serious per-
sonal injury from accidental start-up.
Installing the handle
1. Insert the shaft of the handle into the grip. Align
the screw hole in the grip with the one in the shaft.
Tighten the screw securely.
1
3
2
►
1. Grip 2. Screw 3. Shaft
NOTICE:
Note the direction of the grip. The
screw holes will not be aligned if the grip is not
inserted in the correct direction.
2. Place the spring onto the base.
1
3
2
4
5
6
►
1. Knob 2. Handle clamp 3. Handle 4. Handle holder
5. Spring 6. Base
3. Place the handle between the handle clamp and handle holder.
4. Temporarily attach the handle by tightening the
knob, and adjust the handle position.
5. Fully tighten the knob.
Hex wrench storage
CAUTION:
Be careful not to leave the hex
wrench inserted in the gear case. It may cause
injury and damage to the tool.
When not in use, store the hex wrench as illustrated to
keep it from being lost.
1
►
1. Hex wrench
1
2
►
1. Hex wrench 2. Handle clamp